jenswilly.dk


USB joystick as input to MCU

As kind of a bigger, more long-term project I've been thinking about building a small ROV. This is in no way a novel idea – there are lots and lots og DIY ROV projects out there (Google: build your own ROV). I live by a canal in Copenhagen habour so it would be fun to have a small underwater robot to play with.

There is a lot of hardware going into a ROV project so there's lots of potential for learning new technologies. One of the components is, of course, the control input device. I figured I would forego the usual clunky four-way tact switches and use a decent USB joystick instead – a Saitek Cyborg EVO to be specific. It has pitch, roll, yaw and throttle axes as well as a thumb hat switch and about a million push buttons.

This is a USB joystick and it uses the USB HID protocol. So I need the MCU to work as a USB host. This either involves a big nasty pile of firmware code or a MCU with ROM-based USB host drivers.
My current MCU of choice, the LPC1347, does not have USB host capabilities, but its bigger (but older) brother, the LPC1768 (and other in the LPC17xx series) does have USB host drivers.

However, instead of switching to another MCU I've decided use a dedicated USB host IC. That being the FTDI Vinculum-II. This chip will handle all the USB stuff: enumerating, connecting and so on. And it will be programmed with firmware that simply echoes HID data from the joystick to the MCU using either UART or SPI.

So – off to the store to get myself a development board version of the VNC2 (this one) and we'll see if I can get it working with the joystick…

Leave a Reply